Welcome to the WLED web installer!
Sorry, your browser is not yet supported!
Please try on Desktop Chrome or Edge.
Find binary files here:
Please try on Desktop Chrome or Edge.
Find binary files here:
Could not load the list of WLED versions from GitHub.
Please check your connection and reload the page, or download a binary manually:
Please check your connection and reload the page, or download a binary manually:
Firmware downloads are blocked for this connection.
This installer downloads firmware through download.wled.me, WLED's official CORS-enabled mirror - something on this network or browser (an ad-blocker, firewall, or DNS filter) is blocking that connection, so installing now would write invalid data to your device.
Try disabling any ad-blocker or VPN for this page, or check your network's firewall rules.
You can still download a binary manually:
This installer downloads firmware through download.wled.me, WLED's official CORS-enabled mirror - something on this network or browser (an ad-blocker, firewall, or DNS filter) is blocking that connection, so installing now would write invalid data to your device.
Try disabling any ad-blocker or VPN for this page, or check your network's firewall rules.
You can still download a binary manually:
- Plug in your ESP to a USB port. We will install WLED ... to it.
-
Hit "Install" and select the correct COM port.
You might be missing the drivers for your board.
Here are drivers for chips commonly used in ESP boards:
CP2102 (square chip)
CH34x (rectangular chip)
Make sure your USB cable supports data transfer.
- Get WLED installed and connected in less than 3 minutes!
Mode:
Basic keeps things simple: pick a version and install at 4MB. Switch to Advanced for flash size, memory type, flash mode, and HUB75 layout options.
Flash size:
| Size | Applies to |
|---|---|
| 1MB | |
| 2MB | |
| 4MB | |
| 8MB | |
| 16MB |
Pick the flash size that matches your board - see the chart above for which chip families use each size.
Memory:
Only matters if your board has PSRAM - pick the option matching its interface. Leave on Standard if unsure or your board has none.
Flash mode:
| Mode | Applies to |
|---|---|
| DIO | |
| QIO |
Default matches the flash mode this release's standard build already uses for each chip - safest choice, and required to match an existing bootloader when updating in place. DIO/QIO force that mode where a matching release build exists - see the chart above for which chip(s) that currently applies to.
Layout:
| Board | Chip | Flash size |
|---|---|---|
| ESP32 (default pinout) | ESP32 | 4MB |
| ESP32 (forum pinout) | ESP32 | 4MB |
| Huidu HD-WF2 | ESP32-S3 | 4MB |
| Adafruit MatrixPortal S3 | ESP32-S3 | 8MB |
| MOONHUB / LilyGO T7-S3 | ESP32-S3 | 16MB |
| Waveshare ESP32-S3-RGB-Matrix | ESP32-S3 | 32MB |
Pick the board matching your HUB75 setup - see the chart above for the chip and flash size it needs.
Powered by ESP Web Tools
Downloads mirrored via download.wled.me
GitHub kno.wled.ge
Installer build: